How to Steps
This device layout may vary depending on location. (A Creighton Classroom Training video overview is located on Bridge.)
1. To begin a classroom session:
Press the center button to turn on the display (Press here to begin). The projector will take approximately two minutes to power on.
2. Next select a source by pressing one of the four buttons on the top. It will appear on the projector screen and any available monitors. The Wireless button refers to a Solstice Pod for connecting a personal device. Please refer to https://doit.creighton.edu/solstice for further instructions on the Solstice Pod.
3. The volume buttons located on the right, controls the volume of the device (up and down arrows) when selected. Audio may also be muted using the Mute button.
4. Access the microphone controls by pressing Audio Control on the lower right. This will open a pop-up menu as shown.
This example has two microphones. The handheld and clip on microphone volumes may be adjusted up, down or muted. The program buttons on the right side control the volume on the selected source on the main menu. Press Close when the audio is adjusted appropriately, and you will be returned to the main menu.
5. Any room cameras may be adjusted by pressing Camera Control. It will open another pop up window.
6. The camera can be adjusted to the proper position here. Four presets may also be saved if needed. Press Close to return to the main menu after adjustment.
7. Display will control the main monitor or projector in the room. It may be turned on, off or muted.
8. Pressing Help will open another pop up screen with contact information for further assistance. Press Close to return to the main menu.
. Pressing the System Off button will produce a confirmation page. Press Cancel if the system is to remain on or Power Down to continue turning off the system. Please power off the system when finished with your session.
Connecting a Personal Device
A laptop or other personal device may be connected into the system. To do this, press the HDMI button. Locate the HDMI cable with adapters located on the podium. The adapter used will vary depending on your device.