Body
How to Steps
This device layout may vary depending on location. (A Creighton Classroom Training video overview is located on Bridge.)
This device layout may vary depending on location.
To begin a classroom session:
- Press the ON Button to turn on the display. The projector will take approximately two minutes to power on.
- Select a source from the eight buttons on the right side. It will appear on the projector screen and any available monitors.
- The volume knob located in the left controls the volume of the device selected above. You cannot adjust the room microphones from this system.
- The MUTE Button mutes the output of the podium to the projector. The podium monitors will operate normally.
- This system control example also has a Blu Ray player which may be used.
- The Wireless function refers to a Solstice Pod (it might also be labeled Solstice). Please refer to https://doit.creighton.edu/solstice for Solstice instructions.
- Press the OFF to turn off the display. Please power the system off at the conclusion of each class.
Connecting a Personal Device
A laptop or other personal device may be connected into the system. To do this, press the HDMI button. Locate the HDMI cable with adapters located on the podium. The adapter used will vary depending on your device.
This example uses the USB-C adapter.
If the basic HDMI adapter is needed, remove the adapter as demonstrated here.
If this article did not help, please review the Related Articles in the right hand column or select the Related Services / Offerings and choose Report an Issue or Problem to open a ticket with the myIT Service Desk.