Using Screenbeam to Project Your Device

End State / Outcome

• Project from your device to the screen in the room.

How to Steps

• When the ScreenBeam is selected as an input, you will see an image like the below.
  
  
   
• To connect via HDMI cable:
  • Connect the HDMI cable to your device. An adapter to USB may be required depending on your device. 
  • Ensure your audio output is set to ScreenBeam.
• To connect wirelessly:
  • On PC:
    • Press the Windows key + K.
    • Select the desired ScreenBeam from the list. 
    • It will ask you for a pin.
      • This is displayed on the ScreenBeam screen. 
      • Enter the PIN and hit Connect.
      • You will need to decide on Extended or Mirrored display, depending on preference. 
      • You will need to select the audio output of the ScreenBeam, likely named Digital Output.
      • There will be an icon on your task bar: 
        • You can click this and then click Disconnect
        • You can change your display mode from here.
  • ​​​​​​​​​​​​​​​​​​​​​On a Mac:
    • Open Control Center.
    • Click Screen Mirroring.
    • Select the designated ScreenBeam.
    • It will ask you for a pin.
      • This is displayed on the ScreenBeam screen. 
      • Enter the PIN and hit Connect.
      • You will need to decide on Extended or Entire Screen(Mirror) display, depending on preference. 
      • Click Start Mirroring.
      • You will need to select the audio output of the ScreenBeam, likely named the same as the ScreenBeam for the room.
      • To disconnect:
        • Re-open Screen Mirroring in the Control Center or the Screen Mirroring Button on the top bar.
        • Choose Stop Mirroring.​​​​​​​​​​​​​​